TRIPPLITE(8) NUT Manual TRIPPLITE(8)NAMEtripplite - Driver for Tripp-Lite SmartPro UPS equipment
NOTE
This man page only documents the hardware-specific features of the
tripplite driver. For information about the core driver, see
nutupsdrv(8).
SUPPORTED HARDWARE
This driver should work on the SmartPro line, including the SMART700
and SMART700SER. It only supports SmartPro models that communicate
using the serial port.
EXTRA ARGUMENTS
This driver supports the following optional settings in the
ups.conf(5):
offdelay=num
Time to wait before the UPS is turned off after the kill power
command is sent. The default value is 64 (in seconds).
rebootdelay=num
Set the timer before the UPS is cycled after the reboot command is
sent. The default value is 64 (in seconds).
startdelay=num
Set the time that the UPS waits before it turns itself back on
after a reboot command. The default value is 60 (in seconds).
KNOWN ISSUES AND BUGS
Battery charge information may not be correct for all UPSes. It is
tuned to be correct for a SMART700SER. Other models may not provide
correct information. Information from the manufacturer would be
helpful.
AUTHORS
Rickard E. (Rik) Faith, Nicholas Kain
SEE ALSO
The core driver:
nutupsdrv(8)
Other drivers for Tripp-Lite hardware:
tripplitesu(8), tripplite_usb(8), usbhid-ups(8)
Internet resources:
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/
Network UPS Tools 08/07/2012 TRIPPLITE(8)
