pppoec(1)pppoec(1)NAMEpppoec - PPPoE (Point to Point Protocol over Ethernet) client
SYNOPSIS
interface-name
interface-name config-file] debug-level] log-file] retry-number]
DESCRIPTION
discovers an access concentrator that is willing to offer services to
the client. It obtains a unique session-id from the selected access
concentrator. then forks a daemon which performs the session phase
functionalities of PPPoE as mentioned in RFC 2516.
Options
supports the following options:
Specify the configuration file with absolute path
to be used by The default configuration file
is
Specify the debug level at which logging has to be
enabled. The three debug levels are:
Logs all error messages.
To log these messages, type on
the command line.
Logs all warning messages.
To log these messages, type on
the command line.
Logs function level debug messages.
To log these messages, type on
the command line.
Specify the name of the network interface (e.g.,
to be used for the PPPoE session.
Specify the log file with absolute path, to which pppoec must
log all messages. The default log file is
Specify the frequency of PADI (PPPoE Active
Discovery Initiation) or PADR (PPPoE Active
Discovery Request) packet retransmission when
an access concentrator does not respond to the
client's request. The default value is 3.
EXAMPLES
An example usage of the command is as follows:
WARNINGS
Note that, you cannot run the client daemon without file. See
pppoec.conf(4) for more information. Also, do not use to terminate
Instead, use to kill the client daemon.
AUTHOR
was developed by Hewlett-Packard.
FILES
PPPoE server daemon
PPPoE relay
PPPoE client configuration file
PPP daemon
SEE ALSOpppd(1), pppoerd(1M), pppoesd(1M), pppoec.conf(4).
pppoec(1)