MOPTRACE(1) BSD General Commands Manual MOPTRACE(1)NAMEmoptrace — MOP Trace Utility
SYNOPSISmoptrace [-a] [-d] [-3 | -4]
moptrace [-d] [-3 | -4] [interface]
DESCRIPTIONmoptrace prints the contents of MOP packages on the Ethernet connected to
interface or all known interfaces if ‘-a’ is given.
OPTIONS-a Listen on all the Ethernets attached to the system. If ‘-a’ is
omitted, an interface must be specified.
-d Run in debug mode, with all the output to stderr.
-3 Ignore MOP V3 messages (Ethernet II).
-4 Ignore MOP V4 messages (Ethernet 802.3).
SEE ALSOmopchk(1), mopcopy(1), mopprobe(1), mopd(8)
DECnet Digital Network Architecture Phase IV, Maintenance Operations
Functional Specification V3.0.0, AA-X436A-TK.
DECnet Digital Network Architecture, Maintenance Operations Protocol
Functional Specification V4.0.0, EK-DNA11-FS-001.
AUTHORS
Mats O Jansson ⟨moj@stacken.kth.se⟩
BSD October 2, 1995 BSD