arp man page on 4.4BSD

Man page or keyword search:  
man Server   1065 pages
apropos Keyword Search (all sections)
Output format
4.4BSD logo
[printable version]

ARP(4)			    BSD Programmer's Manual			ARP(4)

     arp - Address Resolution Protocol

     pseudo-device ether

     The Address Resolution Protocol (ARP) is a protocol used to dynamically
     map between Internet host addresses and 10Mb/s Ethernet addresses.	 It is
     used by all the 10Mb/s Ethernet interface drivers.	 It is not specific to
     Internet protocols or to 10Mb/s Ethernet, but this implementation cur-
     rently supports only that combination.

     ARP caches Internet-Ethernet address mappings.  When an interface re-
     quests a mapping for an address not in the cache, ARP queues the message
     which requires the mapping and broadcasts a message on the associated
     network requesting the address mapping.  If a response is provided, the
     new mapping is cached and any pending message is transmitted.  ARP will
     queue at most one packet while waiting for a response to a mapping re-
     quest; only the most recently ``transmitted'' packet is kept.  If the
     target host does not respond after several requests, the host is consid-
     ered to be down for a short period (normally 20 seconds), allowing an er-
     ror to be returned to transmission attempts during this interval.	The
     error is EHOSTDOWN for a non-responding destination host, and
     EHOSTUNREACH for a non-responding router.

     The ARP cache is stored in the system routing table as dynamically-
     created host routes.  The route to a directly-attached Ethernet network
     is installed as a ``cloning'' route (one with the RTF_CLONING flag set),
     causing routes to individual hosts on that network to be created on de-
     mand.  These routes time out periodically (normally 20 minutes after val-
     idated; entries are not validated when not in use).  An entry for a host
     which is not responding is a ``reject'' route (one with the RTF_REJECT
     flag set).

     ARP entries may be added, deleted or changed with the arp(8) utility.
     Manually-added entries may be temporary or permanent, and may be
     ``published'', in which case the system will respond to ARP requests for
     that host as if it were the target of the request.

     In the past, ARP was used to negotiate the use of a trailer encapsula-
     tion.  This is no longer supported.

     ARP watches passively for hosts impersonating the local host (i.e. a host
     which responds to an ARP mapping request for the local host's address).

     duplicate IP address %x!! sent from ethernet address: %x:%x:%x:%x:%x:%x.
     ARP has discovered another host on the local network which responds to
     mapping requests for its own Internet address with a different Ethernet
     address, generally indicating that two hosts are attempting to use the
     same Internet address.

     inet(4),  route(4),  arp(8),  ifconfig(8),	 route(8)

     Plummer, D., "RFC826", An Ethernet Address Resolution Protocol.

     Leffler, S.J., and Karels, M.J., "RFC893", Trailer Encapsulations.

4th Berkeley Distribution	April 18, 1994				     1

List of man pages available for 4.4BSD

Copyright (c) for man pages and the logo by the respective OS vendor.

For those who want to learn more, the polarhome community provides shell access and support.

[legal] [privacy] [GNU] [policy] [cookies] [netiquette] [sponsors] [FAQ]
Polarhome, production since 1999.
Member of Polarhome portal.
Based on Fawad Halim's script.
Vote for polarhome
Free Shell Accounts :: the biggest list on the net