| PostgreSQL 8.4.21 Documentation | ||||
|---|---|---|---|---|
| Prev | Fast Backward | Chapter 15. Installation from Source Code | Fast Forward | Next |
These instructions assume that your existing installation is under the /usr/local/pgsql directory, and that the data area is in /usr/local/pgsql/data. Substitute your paths appropriately.
The internal data storage format typically changes in every major release of PostgreSQL. Therefore, if you are upgrading an existing installation that does not have a version number of "8.4.x", you must back up and restore your data. If you are upgrading from PostgreSQL "8.4.x", the new version can use your current data files so you should skip the backup and restore steps below because they are unnecessary.
If making a backup, make sure that your database is not being updated. This does not affect the integrity of the backup, but the changed data would of course not be included. If necessary, edit the permissions in the file /usr/local/pgsql/data/pg_hba.conf (or equivalent) to disallow access from everyone except you.
To back up your database installation, type:
pg_dumpall > outputfile
If you need to preserve OIDs (such as when using them as foreign keys), then use the -o option when running pg_dumpall.
To make the backup, you can use the pg_dumpall command from the version you are currently running. For best results, however, try to use the pg_dumpall command from PostgreSQL 8.4.21, since this version contains bug fixes and improvements over older versions. While this advice might seem idiosyncratic since you haven't installed the new version yet, it is advisable to follow it if you plan to install the new version in parallel with the old version. In that case you can complete the installation normally and transfer the data later. This will also decrease the downtime.
Shut down the old server:
pg_ctl stop
On systems that have PostgreSQL started at boot time, there is probably a start-up file that will accomplish the same thing. For example, on a Red Hat Linux system one might find that this works:
/etc/rc.d/init.d/postgresql stop
If restoring from backup, rename or delete the old installation directory. It is a good idea to rename the directory, rather than delete it, in case you have trouble and need to revert to it. Keep in mind the directory might consume significant disk space. To rename the directory, use a command like this:
mv /usr/local/pgsql /usr/local/pgsql.old
Install the new version of PostgreSQL as outlined in Section 15.5.
Create a new database cluster if needed. Remember that you must execute these commands while logged in to the special database user account (which you already have if you are upgrading).
/usr/local/pgsql/bin/initdb -D /usr/local/pgsql/data
Restore your previous pg_hba.conf and any postgresql.conf modifications.
Start the database server, again using the special database user account:
/usr/local/pgsql/bin/postgres -D /usr/local/pgsql/data
Finally, restore your data from backup with:
/usr/local/pgsql/bin/psql -d postgres -f outputfile
using the new psql.
Further discussion appears in Section 24.5, including instructions on how the previous installation can continue running while the new installation is installed.