Set a byte-count limit on the amount of data that will be transmitted from a site in response to a single message processed by RepProcessMessage(DatabaseEntry, DatabaseEntry, Int32). The limit is not a hard limit, and the record that exceeds the limit is the last record to be sent.

Namespace:  BerkeleyDB
Assembly:  libdb_dotnet48 (in libdb_dotnet48.dll) Version: 4.8.24.0

Syntax

C#
public void RepSetTransmitLimit(
	uint GBytes,
	uint Bytes
)
Visual Basic (Declaration)
Public Sub RepSetTransmitLimit ( _
	GBytes As UInteger, _
	Bytes As UInteger _
)
Visual C++
public:
void RepSetTransmitLimit(
	unsigned int GBytes, 
	unsigned int Bytes
)

Parameters

GBytes
Type: System..::.UInt32
The number of gigabytes which, when added to Bytes, specifies the maximum number of bytes that will be sent in a single call to RepProcessMessage(DatabaseEntry, DatabaseEntry, Int32).
Bytes
Type: System..::.UInt32
The number of bytes which, when added to GBytes, specifies the maximum number of bytes that will be sent in a single call to RepProcessMessage(DatabaseEntry, DatabaseEntry, Int32).

Remarks

Record transmission throttling is turned on by default with a limit of 10MB.

If both GBytes and Bytes are zero, then the transmission limit is turned off.

See Also