VMS Help DECnet-Plus, DCL Commands, SET, HOST, /MOP  *Conan The Librarian (sorry for the slow response - running on an old VAX)

    Connects your system to a remote system using the MOP protocol.

    Format

       SET HOST/MOP  client-name

1 - Parameter

    CLIENT

       Specifies the name of the MOP CLIENT entity which describes
       the remote system that is the target of the console carrier
       request.  This is an optional parameter.  If omitted, you
       must specify the /CIRCUIT and /ADDRESS qualifiers.

2 - Qualifiers

 2.1 - /ADDRESS=lan-address

     Specifies the LAN address of the remote system.

 2.2 - /BREAK=break-character

     Specifies the character which is to be recognized as a request
     to send a MOP Break protocol command to the remote system.
     Pressing the Ctrl key and this character transmits a MOP Break
     to the remote system.  The default character is \.

 2.3 - /CIRCUIT=circuit-name

     Specifies the name of the MOP CIRCUIT entity over which the
     request should take place.

 2.4 - /DISCONNECT=disconnect-character

     Specifies the character which is to be recognized as a request
     to terminate the connection with the remote system.  Once the
     connection is established, pressing the Ctrl key and this
     character terminates the connection. The default character is ].

 2.5 - /VERIFICATION=hexidecimal-digits

     Specifies the service password of the remote system. A
     verification has 16 hex digits.  If less than 16 digits are
     specified, MOP will pad with zeros on the right.