routing
*Conan The Librarian (sorry for the slow response - running on an old VAX)
|
Library /sys$common/syshlp/net$mgmt_help.hlb routing *Conan The Librarian (sorry for the slow response - running on an old VAX) |
|
The Routing module implements the Network Routing layer described by the
Digital Network Architecture.
The entities that constitute the ROUTING module are listed below. The
indention indicates the hierarchical relationships between the entities.
Routing
Destination area
Destination node
IP destination address
Port
Permitted neighbor
EGP group
EGP neighbor
Circuit
Adjacency
IP address translation
IP adjacency
IP reachable address
Reachable address
The Routing module routes messages in the network and manages the message
packet flow. The Routing module components provide the following functions:
o Routing determines packet paths. A path is the sequence of connected
nodes and links between a source node and a destination node. The combined
knowledge of all the network Routing layer modules of all the nodes in a
network is used to determine the existence of a path, and route the packet
to its destination. The routing component at a routing node has the
following specific functions:
- Extracts and interprets the route header in a packet.
- Performs packet forwarding based on the destination address.
- Performs packet fragmentation where necessary.
- Manages the characteristics of the path and if a node or link fails on
a path, finds an alternate route.
- Interfaces with the Network Routing Subnetwork Dependent sublayer to
receive reports concerning a circuit or node that has failed or the
subsequent recovery of a circuit or node.
- Performs packet reassembly at the destination.
- Returns error reports to the source where necessary, for instance when
the destination is unreachable or when the packet would have needed to
be fragmented but segmentation permitted was not set in the packet.
Segmentation permitted is always set in data packets generated by DNA
nodes. However, non-DNA nodes may do otherwise.
o Congestion control manages the resources used at each packet switching
node each node that permits route-through.
o Packet lifetime control bounds the amount of time a packet can exist in
the network.
o Initialization identifies the adjacent node and the adjacent node's
network routing layer. It also performs node verification, if required.
o Dynamic circuit management -- determines when to dial calls, when to hang
up calls, and on dynamically assigned circuits which DTE address to dial.
It exists only on dynamically established data links.
Whether or not a particular attribute or event of a routing module entity is
supported often depends on the type of node on which the routing module is
operating. The description of an attribute or event indicates the type of
node for which the attribute or event is supported, using the following key:
L1 - The attribute is supported only for Level 1 routers.
L2 - The attribute is supported only for Level 2 routers.
L1,L2 - The attribute is supported only for Level 1 or Level 2 routers.
End - The attribute is supported only for end nodes.
IP - The attribute is supported only for systems that support dual Routing
that is, both OSI and IP routing.
All - The attribute is supported by all implementations.
The routing entity is the top-level entity in the Routing module hierarchy
of entities. The Routing module controls the operation of network routing
within a node.
Additional Information (explode) :
|
|
