Library /sys$common/syshlp/ncphelp.hlb SET, NODE, Examples  *Conan The Librarian (sorry for the slow response - running on an old VAX)

     NCP>SET NODE 5.14 NAME DENVER

         This command sets the node name of node 5.14 to DENVER.

     NCP>SET NODE 2.11 NONPRIVILEGED USER NETNONPRIV PASSWORD NONPRIV -
     _ PRIVILEGED USER NETPRIV PASSWORD PRIV

         This command establishes default privileged and nonprivileged
         access control information for node 2.11.

     NCP>SET NODE 14 ADDRESS 2

         This command associates the information for node 1.14 with a
         new node whose address is 1.2.  This example assumes that the
         executor is in area 1 and that the network is not divided into
         multiple areas.

     NCP>SET NODE LARK HARDWARE ADDRESS 08-00-2B-34-55-FF

         This command associates with the node LARK the hardware
         address originally assigned to the DESVA controller at
         node LARK.  This information in the volatile database can
         be used during downline loading of target node LARK over an
         Ethernet circuit.

     NCP>SET KNOWN NODES ALL

         This command loads all permanent database entries stored
         for all known nodes into the volatile database.

     NCP>SET NODE TESTER CIRCUIT FZA-0

         This command sets the loop node name (TESTER) and identifies
         the circuit over which loop information is to be transmitted.