Library /sys$common/syshlp/ncphelp.hlb SET, NODE  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the SET NODE command to create or modify node parameters in the
 volatile database on the local  node.  Use the DEFINE NODE command to
 create or modify node parameters in the permanent database on the local
 node.

     SET           KNOWN NODES     (parameters ...)
     DEFINE        NODE node-id

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ALL
• ACCESS
• ADDRESS node-address
• CIRCUIT circuit-id
• COUNTER TIMER seconds
• CPU cpu-type
• DIAGNOSTIC FILE file-spec
• DUMP ADDRESS number
• DUMP COUNT number
• DUMP FILE file-spec
• HARDWARE ADDRESS h-address
• HOST node-id
• INBOUND node-type
• KNOWN NODES
• LOAD ASSIST AGENT file-spec
• LOAD ASSIST PARAMETER item
• LOAD FILE file-spec
• MANAGEMENT FILE file-spec
• NAME node-name
• NODE node-id
• NONPRIVILEGED item
• PRIVILEGED item
• RECEIVE PASSWORD hex-password
• SECONDARY LOADER file-spec
• SERVICE CIRCUIT circuit-id
• SERVICE DEVICE device-type
• SERVICE NODE VERSION version
• SERVICE PASSWORD hex-password
• SOFTWARE IDENTIFICATION software-id
• SOFTWARE TYPE software-type
• TERTIARY LOADER file-spec
• TRANSMIT PASSWORD password
• Examples