Library /sys$common/syshlp/ncphelp.hlb SET, MODULE, X25-PROTOCOL, DTE dte-addr  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Identifies a local DTE. See the Public Network Information manual
 for the format of the DTE address.

 SET  MOD X25-PROTOCOL  DTE dte-addr  NETWORK net-name  dte-params
 DEF                                  KNOWN NETWORKS

 If you have only one network set up, that network is the default
 for SET commands.  If you have more than one network set up or if
 you are using a DEFINE command, then you must specify the network
 using either the NETWORK parameter or the KNOWN NETWORKS
 parameter.  In any case, you must follow the DTE qualifiers with
 one or more of the following dte-params.

  Additional Information (explode) :

• ALL
• CALL TIMER seconds
• CHANNELS list
• CLEAR TIMER seconds
• COUNTER TIMER seconds
• DEFAULT DATA bytes
• DEFAULT WINDOW number
• INTERFACE code
• INTERRUPT TIMER seconds
• LINE line-id
• MAXIMUM CIRCUITS count
• MAXIMUM CLEARS count
• MAXIMUM DATA bytes
• MAXIMUM RESETS count
• MAXIMUM RESTARTS count
• MAXIMUM WINDOW count
• RESET TIMER seconds
• RESTART TIMER seconds
• STATE dte-state