Library /sys$common/syshlp/ncphelp.hlb SET, LOGGING  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the SET LOGGING command to create or modify logging parameters in the
 volatile database. Use the DEFINE LOGGING command to create or modify
 logging parameters in the permanent database.

 SET     KNOWN LOGGING        ALL
 DEFINE  LOGGING CONSOLE      NAME prog-name
         LOGGING FILE         STATE  ON
         LOGGING MONITOR             OFF
                                     HOLD

 The CIRCUIT, LINE, and NODE parameters in the following commands are for
 identifying specific sources of events.  The SINK parameter is for
 identifying specific locations to log events.  These source and sink
 parameters are optional.

 SET     KNOWN LOGGING        EVENTS event-list    CIRCUIT circuit-id
 DEFINE  LOGGING CONSOLE      KNOWN EVENTS         LINE line-id
         LOGGING FILE                              NODE node-id
         LOGGING MONITOR                           SINK   EXECUTOR
                                                          NODE node-id

 All underscores found in parameters must be replaced with spaces when
 parameters are used in NCP commands.

  Additional Information (explode) :

• ALL
• CIRCUIT circuit-id
• CONSOLE
• EVENTS event-list
• FILE
• KNOWN_EVENTS
• KNOWN_LOGGING
• LINE line-id
• MONITOR
• NAME prog-name
• NODE node-id
• SINK sink-name
• STATE component-state
• Examples