Library /sys$common/syshlp/ncphelp.hlb SET, LINE, Examples  *Conan The Librarian (sorry for the slow response - running on an old VAX)

      NCP>SET KNOWN LINES ALL

          This command loads all permanent database entries stored
          for all known lines into the volatile database.

      NCP>SET LINE DMC-0 DUPLEX FULL STATE ON

          This command sets line DMC-0 to the ON state in full
          duplex mode.

      NCP>DEFINE LINE DMC-0 PROTOCOL DDCMP POINT

          This command defines the line protocol to DDCMP POINT
          for line DMC-0 in the permanent database.

      NCP>SET LINE DUP-1 RETRANSMIT TIMER 500 MAXIMUM -
      _ RETRANSMITS MAXIMUM BLOCK 133 MAXIMUM WINDOW 2 STATE ON

          This command sets up a line called DUP-1 that uses the
          LAPB protocol and has an associated DUP11-DA synchronous
          line interface with controller number 1.  If a frame is
          not acknowledged within 500 milliseconds, it is
          retransmitted, and this operation is to be performed a
          maximum of 10 times.  The maximum frame size is 133
          bytes, and the maximum number of frames for which
          outstanding acknowledgments are allowed is 2.  The line
          is operational.

      NCP>SET LINE KMX-0-0 MICROCODE DUMP BARRY

          This command dumps the microcode of the KMX to the file
          SYS$ERRORLOG:BARRY.DMP.

      NCP>SET LINE KMV-0 NETWORK PSS STATE ON

          This command sets up the line KMV-0 to the PSS network.

      NCP>SET LINE DMF-* CONTROLLER LOOPBACK

          This command sets the controller mode to loopback for all
          DMF lines.