Library /sys$common/syshlp/ncphelp.hlb SET, EXECUTOR, NODE  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the SET EXECUTOR NODE command to set the default executor for  all
 NCP  commands.   The  executor  is  the  node  on  which  the  Network
 Management Listener (NML) runs to perform these  commands.  (Do not
 use the TELL prefix with the SET EXECUTOR NODE command.)

 Note that the NODE keyword must  appear  as  the  third  keyword  when
 entering  the  command.   The  remaining information may appear in any
 order thereafter, except the node-spec  which  must  follow  the  NODE
 keyword.  Access control information is optional.

 SET     EXECUTOR        NODE node-spec          ACCOUNT account
                                                 PASSWORD password
                                                 USER user-id

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ACCOUNT account
• NODE node-spec
• PASSWORD password
• USER user-id
• Examples