Library /sys$common/syshlp/ncphelp.hlb SET, EXECUTOR, Examples  *Conan The Librarian (sorry for the slow response - running on an old VAX)

      NCP>SET EXECUTOR ALL

          This command loads all permanent database entries
          stored for the local node into the volatile database.

      NCP>SET EXECUTOR ADDRESS 2.11

          This command sets the executor node's address to 2.11.
          (The executor must be in the OFF state to set the
          ADDRESS parameter.)

      NCP>SET EXECUTOR STATE ON

          This command sets the executor node's operational state
          to ON.

      NCP>SET NODE 2.13 NAME BIRDY
      NCP>SET EXECUTOR ALIAS NODE BIRDY

          The SET NODE command establishes a node address 2.13 with
          the associated node name BIRDY.  The SET EXECUTOR ALIAS
          NODE command then establishes the node name BIRDY as the
          alias node identifier.  (The executor must be in the OFF
          state to set the ALIAS NODE parameter.)

      NCP>SET EXECUTOR ALIAS INCOMING ENABLED

          This command specifies that incoming connect requests
          directed to the alias node identifier are permitted.

      NCP>DEFINE EXECUTOR NAME ROBIN

          This command defines the executor node's name to ROBIN
          in the permanent database.