Library /sys$common/syshlp/ncphelp.hlb SET, CIRCUIT  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the SET CIRCUIT command to create or modify circuit
 parameters in the volatile database.  Most parameters cannot be
 SET when the circuit is in the ON state.  However, the COST,
 COUNTER TIMER, HELLO TIMER, MAXIMUM ROUTERS, STATE, TRANSMIT
 TIMER, and VERIFICATION can be changed with the circuit is in the
 ON state.

 SET     KNOWN CIRCUITS       (parameters ...)
 DEFINE  CIRCUIT circuit-id

 Use the DEFINE CIRCUIT command to create or modify permanent
 circuit parameters.

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ALL
• ACTIVE BASE base
• ACTIVE INCREMENT increment
• BABBLE TIMER milliseconds
• CHANNEL number
• CIRCUIT circuit-id
• COST number
• COUNTER TIMER seconds
• DEAD THRESHOLD count
• DTE dte-addr
• DYING BASE base
• DYING INCREMENT increment
• DYING THRESHOLD number
• HELLO TIMER seconds
• INACTIVE BASE base
• INACTIVE INCREMENT increment
• INACTIVE THRESHOLD number
• KNOWN CIRCUITS
• MAXIMUM BUFFERS number
• MAXIMUM DATA number
• MAXIMUM RECALLS number
• MAXIMUM ROUTERS number
• MAXIMUM TRANSMITS number
• MAXIMUM WINDOW count
• NETWORK net-name
• NUMBER dte-addr
• OWNER EXECUTOR
• POLLING STATE state
• RECALL TIMER seconds
• ROUTER PRIORITY number
• SERVICE mode
• STATE circuit-state
• TRANSMIT TIMER milliseconds
• TRIBUTARY tributary-address
• TYPE X25
• USAGE
• VERIFICATION option
• Examples