Library /sys$common/syshlp/ncphelp.hlb LOOP, CIRCUIT  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the LOOP CIRCUIT command to test a specified circuit in the
 network.  This command does not apply to X.25 circuits.  The
 parameters are optional and can be entered in any order.

 LOOP   CIRCUIT circuit-id   ASSISTANT PHYSICAL ADDRESS p-address
                             ASSISTANT NODE node-id
                             COUNT number
                             HELP help-type
                             LENGTH number
                             NODE node-id
                             PHYSICAL ADDRESS p-address
                             WITH
                               MIXED
                               ONES
                               ZEROES

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ASSISTANT NODE node-id
• ASSISTANT PHYSICAL ADDRESS p-address
• COUNT number
• HELP help-type
• LENGTH number
• NODE node-id
• PHYSICAL ADDRESS p-address
• WITH data-type
• Examples