Library /sys$common/syshlp/ncphelp.hlb LOAD, VIA  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the LOAD VIA command to downline load software to a target node
 using the specified circuit.  The target node identification this is
 associated with the service circuit is obtained from the volatile
 database on the executor node.  If the target node is on a broadcast
 circuit, the PHYSICAL ADDRESS parameter must be specified in this
 command.

 LOAD    VIA circuit-id     (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ADDRESS node-address
• CPU cpu-type
• FROM file-spec
• HOST node-id
• LOAD ASSIST AGENT file-spec
• LOAD ASSIST PARAMETER item
• MANAGEMENT FILE file-spec
• NAME node-name
• PHYSICAL ADDRESS p-address
• SECONDARY LOADER file-spec
• SERVICE DEVICE device-type
• SERVICE PASSWORD hex-password
• SOFTWARE IDENTIFICATION software-id
• SOFTWARE TYPE file-type
• TERTIARY LOADER file-spec
• Examples