Library /sys$common/syshlp/ncphelp.hlb LOAD, NODE  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the LOAD NODE command to downline loadsoftware to a target node,
 using either the identified circuit (if specified) or the circuit
 obtained from the volatile database.  Any parameter left unspecified
 in the command defaults to whatever entry for the target node is
 specified in the volatile node database on the executor node.

 LOAD    NODE node-id    (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• ADDRESS node-address
• CPU
• FROM file-spec
• HOST node-id
• LOAD ASSIST AGENT file-spec
• LOAD ASSIST PARAMETER item
• MANAGEMENT FILE file-spec
• NAME node-name
• PHYSICAL ADDRESS p-address
• SECONDARY LOADER file-spec
• SERVICE DEVICE device-type
• SERVICE PASSWORD hex-password
• SOFTWARE IDENTIFICATION software-id
• SOFTWARE TYPE file-type
• TERTIARY LOADER file-spec
• VIA circuit-id
• Examples