Library /sys$common/syshlp/ncphelp.hlb HELP  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 The Network Control Program (NCP) is the utility program system managers
 and operators use to configure and control DECnet for OpenVMS networks.
 System managers can also use NCP to monitor network resources and test
 network components.

 Use the HELP command to display information at various levels of detail.
 For example, each HELP display includes a list of command words under an
 "Additional Information Available" section. These command words serve as
 topics for the next level of information accessible by the HELP command.
 In the general format of the HELP command shown below, the topic is a
 command word from the list:

       NCP>HELP    [topic...]

 You can abbreviate command words when you issue the command. Once you
 enter a particular level of detail, that level becomes the current
 level for accessing information. Through the use of the prompts "TOPIC?"
 and "SUBTOPIC?" you can return to a higher or lower level of information,
 respectively. The highest level of information is the general
 description of the help facility.

  Additional Information (explode) :

• Parameters