Library /sys$common/syshlp/ncphelp.hlb CONNECT, NODE  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the CONNECT NODE command to set up a logical connection between
 the host node and the console interface on a specified target node.
 Both the host node and the target node must be on the same broadcast
 circuit.

 To define information for the target node in the volatile database,
 use the NCP command SET NODE to specify the ADDRESS, SERVICE CIRCUIT,
 SERVICE PASSWORD,  and HARDWARE ADDRESS parameters for the target
 node.  Once you set these parameters, you can override them by
 specifying new parameters in the CONNECT command.

 CONNECT NODE node-id    (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• PHYSICAL ADDRESS p-address
• SERVICE PASSWORD hex-password
• VIA circuit-id
• Examples