Library /sys$common/syshlp/ncphelp.hlb CLEAR, MODULE, X25-PROTOCOL  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the CLEAR MODULE X25-PROTOCOL command to remove  the protocol
 module component from the volatile database or reset the individual
 parameters.  (Parameters are reset to their default values; the
 network values are specified by the PROFILE parameter of the SET
 MODULE X25-PROTOCOL command.)

 Use the PURGE MODULE X25-PROTOCOL command  to remove the parameters of
 the protocol module component from the  permanent database.  Note that
 the word MODULE is optional.

 Use separate CLEAR or PURGE MODULE X25-PROTOCOL commands to clear or
 purge the network, the DTE, or the group.  You may not be able to
 change the values of some of the network parameters (see the Public
 Network Information manual).

 CLEAR MOD X25-PROTOCOL DTE dte-addr  NETWORK net-name  dte-param(s)
 PURGE                  KNOWN DTES    KNOWN NETWORKS

 CLEAR MOD X25-PROTOCOL GROUP group-name ALL
 PURGE                  KNOWN GROUPS ALL

 CLEAR MOD X25-PROTOCOL NETWORK net-name ALL
 PURGE                  KNOWN NETWORKS ALL

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

  Additional Information (explode) :

• DTE dte-addr
• GROUP group-name
• KNOWN_DTES
• KNOWN_GROUPS
• KNOWN_NETWORKS
• NETWORK net-name
• Examples