Library /sys$common/syshlp/ncphelp.hlb CLEAR, LINE  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 Use the CLEAR LINE command to reset line parameters to the default value
 (if any) or remove the entries and parameters from the volatile database.
 For an X25 line, the default value depends on the profile that is
 associated with the NETWORK parameter.

     CLEAR   KNOWN LINES     (parameters...)
             LINE line-id

 Use the PURGE LINE command to remove line parameters from the permanent
 database on the local node or DTE.

     PURGE   KNOWN LINES     (parameters...)
             LINE line-id

 All underscores found in parameters must be replaced with spaces when
 parameters are used in NCP commands.

  Additional Information (explode) :

• ALL
• CONTROLLER
• COUNTER TIMER
• DEAD TIMER
• DELAY TIMER
• ECHO_DATA
• ECHO_LENGTH
• ECHO_TARGET
• HANGUP
• HOLDBACK TIMER
• INTERFACE
• KNOWN LINES
• LINE line-id
• LINE_SPEED
• MAXIMUM_BLOCK
• MAXIMUM_RETRANSMITS
• NETWORK
• NIF TARGET
• PROTOCOL
• RECEIVE BUFFERS
• REQUESTED TRT
• RESTRICTED TOKEN TIMEOUT
• RING PURGER ENABLE
• SCHEDULING TIMER
• SERVICE TIMER
• SIF_CONFIGURATION_TARGET
• SIF_OPERATION_TARGET
• STATE
• STREAM TIMER
• SWITCH
• TRANSMIT PIPELINE
• VALID TRANSMISSION TIME
• Examples