Library /sys$common/syshlp/ncphelp.hlb CLEAR, CIRCUIT  *Conan The Librarian (sorry for the slow response - running on an old VAX)

 The CLEAR CIRCUIT command resets circuit parameters in the volatile
 database to the default value (if any), or removes them from the volatile
 database.

 CLEAR   KNOWN CIRCUITS        (parameters...)
         CIRCUIT circuit-id

 The PURGE CIRCUIT command always removes circuit parameters from the
 permanent database.

 PURGE   KNOWN CIRCUITS        (parameters...)
         CIRCUIT circuit-id

 All underscores found in parameters must be replaced with spaces when
 parameters are used in NCP commands.

  Additional Information (explode) :

• ACTIVE_BASE
• ACTIVE_INCREMENT
• ALL
• BABBLE TIMER
• CIRCUIT circuit-id
• COST
• COUNTER TIMER
• DEAD THRESHOLD
• DTE
• DYING_BASE
• DYING_INCREMENT
• DYING_THRESHOLD
• HELLO TIMER
• INACTIVE_BASE
• INACTIVE_INCREMENT
• INACTIVE_THRESHOLD
• KNOWN CIRCUITS
• MAXIMUM_BUFFERS
• MAXIMUM_RECALLS
• MAXIMUM_ROUTERS
• MAXIMUM_TRANSMITS
• NETWORK
• NUMBER
• RECALL TIMER
• ROUTER PRIORITY
• TRANSMIT TIMER
• Examples