set, session_control, application
*Conan The Librarian (sorry for the slow response - running on an old VAX)
|
Library /sys$common/syshlp/nclhelp.hlb set, session_control, application *Conan The Librarian (sorry for the slow response - running on an old VAX) |
|
set [node node-id] session control -
application object-name-or-object-number ...
You can identify an application with an object name or an object
number. Usually, applications are identified by network object
number 0, but you can optionally assign it a nonzero object number,
in the range from 128 to 255. A nonzero object number can be
specified without an application name. Object numbers 1 through
127 are reserved for use by Tru64. Specific network services
are identified by nonzero object numbers; for example, 27
represents the mail utility.
This Set command modifies attributes of a session control application
entity, which stores information about an end user that is activated
for receipt of an incoming connection request when the request
contains that end user's name in its destination name field.
The modifiable session control application attributes and their
data types [in brackets] are:
accept mode [immediate or deferred] (Tru64 UNIX)
addresses [set of end-user specifications]
allow decnet-internet gateway access [boolean] (Tru64 UNIX)
client [client-id]
data abstraction [message or stream] (Tru64 UNIX)
image name [file-spec]
incoming alias [boolean] (Tru64 UNIX)
incoming osi tsel [hex-string] (OpenVMS)
incoming proxy [boolean]
maximum instances [integer] (Tru64 UNIX)
network priority [integer] (OpenVMS)
node synonym [boolean]
outgoing alias [boolean] (OpenVMS)
outgoingalias name [fullname] (OpenVMS)
outgoing proxy [boolean] (OpenVMS)
programming interface [Phase IV or Phase V] (Tru64 UNIX)
user name [username]
On OpenVMS, the recommended method of modifying session control
application attributes is to run NET$CONFIGURE and choose Option 7.
The configuration information for the applications is then written
to the SYS$MANAGER:NET$APPLICATION_STARTUP.NCL script so the
applications can be re-set on reboot.
If you wish to modify these attributes manually, you may refer
specific command examples in the attribute descriptions.
Additional Information (explode) :
|
|
