Library /sys$common/syshlp/nclhelp.hlb enable, x25_protocol  *Conan The Librarian (sorry for the slow response - running on an old VAX)

    The x25 protocol dte enable command starts the operation of the
    specified DTE. When the procedure completes, the status attribute
    state may be running, synchronizing, or unsynchronized.

    enable  [node node-id] x25 protocol dte dte-name

    The enable command will fail if the inbound dte class, link
    service provider, or x25 address characteristics are not set.
    The command will also fail if:

    o  There is a mismatch between the protocol profile and the link
       service provider profile.

    o  The link service provider either does not exist or is in use
       by someone else.

    o  The link service provider does not provide a maximum data size
       of the greater of 260, DTE maximum packet size +4.

    Example:

    enable x25 protocol dte dte-0

  Additional Information (explode) :

• Exception Messages