/sys$common/syshlp/helplib.hlb SET, HOST, /LAT, Examples  *Conan The Librarian (sorry for the slow response - running on an old VAX)

    1.$ SET HOST/LAT SORTER
      %LAT-S-CONNECTED, session to SORTER established
      %LAT-I-TODISCON, type ^\ to disconnect the session
      Username: BARKER
      Password:
         .
         .
         .

      $ LOGOUT
      BARKER logged out at 30-DEC-2001  11:04:51.45
      %LAT-I-DISCONNECTED, session disconnected from SORTER
      -LAT-I-END, control returned to node HOME
      $

      This SET HOST/LAT command connects the user to the service
      SORTER, which is a computer system. The first message confirms
      that the user has been connected to that service. The second
      message informs the user how to disconnect the session. (The
      user can also disconnect the session by logging out from
      SORTER.) SORTER then prompts for the username and password.
      Use the normal login procedure to log in to the system. When
      the user logs out of the service SORTER, the terminal displays
      the DCL command prompt of the user's local processor system
      (HOME).

    2.$ SET HOST/LAT/DESTINATION_PORT=BOSTON-
      _$ /NODE=STATE/DISCONNECT=F BUDGET

      This command connects the user's terminal to the service BUDGET
      that is offered on port BOSTON, on service node STATE. The user
      can disconnect the session by pressing Ctrl/F.

    3.$ SET HOST/LAT PURSE
      Password:

      This command attempts to connect the user's terminal to the
      service PURSE. The service PURSE is password protected, so the
      user is prompted for a password. The user could have specified
      the password within the SET HOST/LAT command, as shown in the
      next example.

    4.$ SET HOST/LAT/PASSWORD=BEOR PURSE

      This command connects the user's terminal to the password-
      protected service PURSE. The password is BEOR.