/sys$common/syshlp/helplib.hlb ANALYZE, /RMS_FILE, Qualifiers, /OUTPUT  *Conan The Librarian (sorry for the slow response - running on an old VAX)

    /OUTPUT=filesspec
    /NOOUTPUT

    Identifies the destination file for the results of the analysis.
    The /NOOUTPUT qualifier specifies that no output file is to be
    created. In all cases, the Analyze/RMS_File utility displays a
    message indicating whether the data file has errors.

    /CHECK          Places the integrity report in the output file.
                    The default file type is .ANL, and the default
                    file name is ANALYZE. If you omit the output-
                    filespec parameter, output is written to the
                    current SYS$OUTPUT device, which is generally
                    your terminal.
    /FDL            Places the resulting FDL specification in the
                    output file. The default file type is .FDL, and
                    the default file name is that of the input file.
    /INTERACTIVE    Places a transcript of the interactive session in
                    the output file. The default file type is .ANL,
                    and the default file name is ANALYZE. If you omit
                    the output-filespec parameter, no transcript of
                    your interactive session is produced.
    /RU_JOURNAL     Places the recovery-unit journal information in
                    the output file. The default file type is .ANL,
                    and the default file name is ANALYZE. If you
                    omit the output-filespec parameter, output is
                    written to the current SYS$OUTPUT device, which
                    is generally your terminal.
    /STATISTICS     Places the statistics report in the output file.
                    The default file type is .ANL, and the default
                    file name is ANALYZE. If you omit the output-
                    filespec parameter, output is written to the
                    current SYS$OUTPUT device, which is generally
                    your terminal.
    /SUMMARY        Places the summary report in the output file.
                    The default file type is .ANL, and the default
                    file name is ANALYZE. If you omit the output-
                    filespec parameter, output is written to the
                    current SYS$OUTPUT device, which is generally
                    your terminal.