openl2tpd.conf(5) OpenL2TP Manual openl2tpd.conf(5)NAMEopenl2tpd.conf - OpenL2TP configuration file
SYNOPSIS
This document describes the configuration file syntax of OpenL2TP.
DESCRIPTION
The configuration file syntax is the same as that written by l2tpcon‐
fig's config save command. The file contains a number of l2tpconfig
create and modify commands, though the commands aren't processed by
l2tpconfig - they are processed by openl2tpd directly when it starts up
and again if it receives a SIGHUP signal.
The preferred way to save and restore openl2tpd configuration informa‐
tion is to use the l2tpconfig utility's config save and config restore
commands. The local configuration file support is usually enabled only
when l2tpconfig is not available.
See l2tpconfig(1) for a list of all available create and modify com‐
mands.
A # character on the first line is used to begin a comment line.
A \ character at the end of a line is used to break a long command into
multiple lines.
Commands are processed in order. If a tunnel create command references
a named peer profile, the profile must be created before the tunnel
create command.
A config file written by the config save command of the l2tpconfig
utility may be copied to /etc/openl2tpd.conf if desired, in order to
have the configuration automatically applied when openl2tpd restarts.
However, the preferred method to reload saved configuration is to use
l2tpconfig config restore file=xxx.
EXAMPLES
tunnel profile create profile_name=one \
hello_timeout=30
tunnel create tunnel_name=one dest_ipaddr=10.1.2.3 \
profile_name=one
SEE ALSOl2tpconfig(1), openl2tp(7), openl2tpd(8),
OpenL2TP 13 August 2007 openl2tpd.conf(5)
