NDMP(4)NDMP(4)NAMEndmp - configuration properties for Solaris Network Data Management
Protocol (NDMP) server
DESCRIPTION
The behavior of the Solaris NDMP server is specified by property values
that are stored in the Service Management Facility, smf(5).
An authorized user can use the ndmpadm(1M) command to set global values
for these properties in SMF.
You can set the following properties by using the ndmpadm set command:
backup-quarantine
Backup the files marked as quarantined by AV.
Acceptable values are yes or no. The default is
no.
dar-support
Set the Direct Access Recovery mode. Acceptable
values are yes or no. The default is no.
debug-path
The path to which to save the debug log. The
default is /var/log/ndmp.
debug-mode
Enable or disable debug log messages.
dump-pathnode
Enable or disable backing up the directories
containing modified files or directories in
dump(1) backup format. Acceptable values are
yes or no. The default is no.
ignore-ctime
Determines whether the change timestamp (ctime)
of files and directories is used to determine
whether a file should be backed up in level
backup. If this parameter is set to yes, only
the modification time (mtime) of the file or
directory determines whether it should be
backed up. Acceptable values are yes or no. The
default value is no.
overwrite-quarantine
Restore quarantined files on top of current
files if they already exist. Acceptable values
are yes or no. The default value is no.
restore-quarantine
Restore the files that had been marked as quar‐
antined by AV and are backed up. Acceptable
values are yes or no. The default value is no.
tar-pathnode
Enable or disable backing up the directories
containing modified files or directories in
tar(1) backup format. Acceptable values are yes
or no. The default value is no.
token-maxseq
Set the maximum sequence number for subsequent
token-based incremental backup in NDMP-V4. The
default value is 9. There are two limits for
this value: soft-limit, which is 59, and hard-
limit, equal to 64. If the token sequence num‐
ber, passed by the DMA, is between the soft and
hard limits, a warning message is issued to the
DMA. The token sequence number can never exceed
the hard-limit value.
version
Set the maximum active NDMP protocol version.
Valid values are currently 2, 3, and 4. The
default is 4.
The following property can only be set when using the ndmpadm enable or
ndmpadm disable command:
auth-type
Sets the password encryption type for the authentication
of local users. Valid values are cram-md5 or cleartext.
ATTRIBUTES
See attributes(5) for descriptions of the following attributes:
┌────────────────────┬─────────────────┐
│ ATTRIBUTE TYPE │ ATTRIBUTE VALUE │
├────────────────────┼─────────────────┤
│Interface Stability │ Committed │
└────────────────────┴─────────────────┘
SEE ALSOdump(1), tar(1), ndmpadm(1M), ndmpd(1M), attributes(5), smf(5)
Feb 24, 2014 NDMP(4)
