KILLPG(P) POSIX Programmer's Manual KILLPG(P)PROLOG
This manual page is part of the POSIX Programmer's Manual. The Linux
implementation of this interface may differ (consult the corresponding
Linux manual page for details of Linux behavior), or the interface may
not be implemented on Linux.
NAMEkillpg - send a signal to a process group
SYNOPSIS
#include <signal.h>
int killpg(pid_t pgrp, int sig);
DESCRIPTION
The killpg() function shall send the signal specified by sig to the
process group specified by pgrp.
If pgrp is greater than 1, killpg(pgrp, sig) shall be equivalent to
kill(-pgrp, sig). If pgrp is less than or equal to 1, the behavior of
killpg() is undefined.
RETURN VALUE
Refer to kill() .
ERRORS
Refer to kill() .
The following sections are informative.
EXAMPLES
None.
APPLICATION USAGE
None.
RATIONALE
None.
FUTURE DIRECTIONS
None.
SEE ALSOgetpgid() , getpid() , kill() , raise() , the Base Definitions volume
of IEEE Std 1003.1-2001, <signal.h>
COPYRIGHT
Portions of this text are reprinted and reproduced in electronic form
from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology
-- Portable Operating System Interface (POSIX), The Open Group Base
Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of
Electrical and Electronics Engineers, Inc and The Open Group. In the
event of any discrepancy between this version and the original IEEE and
The Open Group Standard, the original IEEE and The Open Group Standard
is the referee document. The original Standard can be obtained online
at http://www.opengroup.org/unix/online.html .
IEEE/The Open Group 2003 KILLPG(P)
