IWN(4) BSD Kernel Interfaces Manual IWN(4)NAMEiwn — Intel Wireless 4965AGN IEEE 802.11 driver
SYNOPSIS
iwn* at pci? dev ? function ?
DESCRIPTION
The iwn driver provides support for Intel Wireless WiFi Link 4965AGN Mini
PCI Express network adapters.
By default, the iwn driver configures the adapter for BSS operation (aka
infrastructure mode). This mode requires the use of an access point.
For more information on configuring this device, see ifconfig(8).
CONFIGURATION
The iwn driver can be configured at runtime with ifconfig(8) using the
following parameters:
bssid bssid
Set the desired BSSID.
-bssid Unset the desired BSSID. The interface will automatically select
a BSSID in this mode, which is the default.
chan n Set the channel (radio frequency) to be used by the driver based
on the given channel ID n.
-chan Unset the desired channel to be used by the driver. The driver
will automatically select a channel in this mode, which is the
default.
media media
The iwn driver supports the following media types:
autoselect Enable autoselection of the media type and options.
mediaopt opts
The iwn driver supports the following media options:
monitor Select monitor mode.
-mediaopt opts
Disable the specified media options on the driver and return it
to the default mode of operation (BSS).
mode mode
The iwn driver supports the following modes:
11a Force 802.11a operation.
11b Force 802.11b operation.
11g Force 802.11g operation.
nwid id
Set the network ID. The id can either be any text string up to
32 characters in length, or a series of hexadecimal digits up to
64 digits. An empty id string allows the interface to connect to
any available access points. By default the iwn driver uses an
empty string. Note that network ID is synonymous with Extended
Service Set ID (ESSID).
nwkey key
Enable WEP encryption using the specified key. The key can
either be a string, a series of hexadecimal digits (preceded by
‘0x’), or a set of keys of the form “n:k1,k2,k3,k4”, where ‘n’
specifies which of the keys will be used for transmitted packets,
and the four keys, “k1” through “k4”, are configured as WEP keys.
If a set of keys is specified, a comma (‘,’) within the key must
be escaped with a backslash. Note that if multiple keys are
used, their order must be the same within the network. iwn is
capable of using both 40-bit (5 characters or 10 hexadecimal dig‐
its) or 104-bit (13 characters or 26 hexadecimal digits) keys.
-nwkey Disable WEP encryption. This is the default mode of operation.
EXAMPLES
The following example configures iwn0 to join whatever network is avail‐
able on boot, using WEP key “0x1deadbeef1”, channel 11, obtaining an IP
address using DHCP:
dhcp NONE NONE NONE nwkey 0x1deadbeef1 chan 11
Configure iwn0 for WEP, using hex key “0x1deadbeef1”:
# ifconfig iwn0 nwkey 0x1deadbeef1
Return iwn0 to its default settings:
# ifconfig iwn0 -bssid -chan media autoselect \
nwid "" -nwkey
Join an existing BSS network, “my_net”:
# ifconfig iwn0 192.168.1.1 netmask 0xffffff00 nwid my_net
DIAGNOSTICS
iwn%d: device timeout A frame dispatched to the hardware for transmis‐
sion did not complete in time. The driver will reset the hardware. This
should not happen.
iwn%d: fatal firmware error For some reason, the firmware crashed. The
driver will reset the hardware. This should not happen.
iwn%d: radio is disabled by hardware switch The radio transmitter is off
and thus no packet can go out. The driver will reset the hardware. Make
sure the laptop radio switch is on.
iwn%d: error %d, could not read firmware %s For some reason, the driver
was unable to read the firmware image from the filesystem. The file
might be missing or corrupted.
iwn%d: could not get firmware handle %s
iwn%d: could not read firmware The driver was unable to find the file
with the proper firmware image. It should be located in
/libdata/firmware/if_iwn.
iwn%d: firmware file too short: %d bytes The firmware image is corrupted
and can't be loaded into the adapter.
iwn%d: could not load firmware An attempt to load the firmware into the
adapter failed. The driver will reset the hardware.
SEE ALSOarp(4), ifmedia(4), intro(4), netintro(4), pci(4), ifconfig(8)AUTHORS
The iwn driver and this man page were written by Damien Bergamini
⟨damien.bergamini@free.fr⟩.
BSD May 27, 2010 BSD
