IP-VRF(8) Linux IP-VRF(8)NAMEip-vrf - run a command against a vrf
SYNOPSIS
ip vrf { COMMAND | help }
ip vrf show [ NAME ]
ip vrf identify [ PID ]
ip vrf pids NAME
ip vrf exec [ NAME ] command...
DESCRIPTION
A VRF provides traffic isolation at layer 3 for routing, similar to how
a VLAN is used to isolate traffic at layer 2. Fundamentally, a VRF is a
separate routing table. Network devices are associated with a VRF by
enslaving the device to the VRF. At that point network addresses
assigned to the device are local to the VRF with host and connected
routes moved to the table associated with the VRF.
A process can specify a VRF using several APIs -- binding the socket to
the VRF device using SO_BINDTODEVICE, setting the VRF association using
IP_UNICAST_IF or IPV6_UNICAST_IF, or specifying the VRF for a specific
message using IP_PKTINFO or IPV6_PKTINFO.
By default a process is not bound to any VRF. An association can be set
explicitly by making the program use one of the APIs mentioned above or
implicitly using a helper to set SO_BINDTODEVICE for all IPv4 and IPv6
sockets (AF_INET and AF_INET6) when the socket is created. This ip-vrf
command is a helper to run a command against a specific VRF with the
VRF association inherited parent to child.
ip vrf show [ NAME ] - Show all configured VRF
This command lists all VRF and their corresponding table ids. If
NAME is given, then only that VRF and table id is shown. The
latter command is useful for scripting where the table id for a
VRF is needed.
ip vrf exec [ NAME ] cmd ... - Run cmd against the named VRF
This command allows applications that are VRF unaware to be run
against a VRF other than the default VRF (main table). A command
can be run against the default VRF by passing the "default" as
the VRF name. This is useful if the current shell is associated
with another VRF (e.g, Management VRF).
ip vrf identify [PID] - Report VRF association for process
This command shows the VRF association of the specified process.
If PID is not specified then the id of the current process is
used.
ip vrf pids NAME - Report processes associated with the named VRF
This command shows all process ids that are associated with the
given VRF.
CAVEATS
This command requires a kernel compiled with CGROUPS and CGROUP_BPF
enabled.
The VRF helper *only* affects network layer sockets.
EXAMPLES
ip vrf exec red ssh 10.100.1.254
Executes ssh to 10.100.1.254 against the VRF red table.
SEE ALSOip(8), ip-link(8), ip-address(8), ip-route(8), ip-neighbor(8)AUTHOR
Original Manpage by David Ahern
iproute2 7 Dec 2016 IP-VRF(8)
