BFE(4) BSD Kernel Interfaces Manual BFE(4)NAMEbfe — Broadcom BCM4401 Ethernet Device Driver
The bfe driver provides support for Broadcom BCM4401 based Fast Ethernet
The bfe driver supports the following media types:
autoselect Enable autoselection of the media type and options
10baseT/UTP Set 10Mbps operation
100baseTX Set 100Mbps (fast ethernet) operation
The bfe driver supports the following media options:
full-duplex Set full duplex operation
For further information on configuring this device, see ifconfig(8).
bfe%d: couldn't map memory A fatal initialization error has occurred.
bfe%d: couldn't map interrupt A fatal initialization error has occurred.
bfe%d: failed to allocate DMA resources There are not enough mbufs
available for allocation.
bfe%d: watchdog timeout -- resetting The device has stopped responding
to the network, or there is a problem with the network connection
SEE ALSOarp(4), ifmedia(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)HISTORY
The bfe device driver first appeared in FreeBSD 5.1.
The bfe device driver was written by Stuart Walsh and Duncan Barclay.
This manual page was written by Stuart Walsh.
BSD September 4, 2003 BSD